For electronic cigarette users know that maintenance and care is something to take into account to make it work perfectly. But there are many of them who are new and do not know what steps they should follow or how they should do to be able to clean the atomizer of the electronic cigarette.
Below we will give you some tips or steps to follow to be able to clean your electronic cigarette.
To be able to clean the atomizer of the electronic cigarette, the first thing you have to do is to disassemble the device, once we have all the parts removed, both above and below the atomizer, we will have to discard the e-liquid. Remember to know where each extracted part of the atomizer goes.
Once we have all the parts separated, take the atomizer and run it under hot water. About 20 seconds is enough for the little e-liquid that is left to be cleaned properly. Once we have finished, we take a paper towel or a microfiber cloth and introduce it through one of the openings. It is important to turn it and pass it from front to back so as not to leave any water residue.
The other parts that we have extracted it is advisable to leave them in a container full of hot water to be able to make a more accurate cleaning. Use a microfiber cloth or a new toothbrush to clean the parts.
To finish, let the parts and the atomizer dry for 10 minutes, because even if we have cleaned them properly, there will be water residues. Once they are dry it is time to reassemble everything and fill it.
As you can see, the steps to follow to clean your atomizer are simple, however, there are different ways to clean it, such as using a jewelry cleaning machine to clean resistant deposits, using a strong liquor such as vodka to clean the resistant e-liquid deposits, among others.
It is advisable to clean these accessories on a weekly basis to avoid damaging the device. Also try to wash the atomizer every time you are going to change flavor, so as not to have a somewhat unpleasant experience and finally try to change the parts when necessary, it is not worth to be holding a certain time until the resistance does not work. for example.